Korg MS-04 Modulation Pedal

The Korg MS-04 accessory was contemporary with the MS-series analogue monosynths in the late ’70s and early ’80s. It looks like a standard volume pedal, and weighs in around 1kg owing to its sturdy metal construction. Essentially it’s a bender pedal that provides a variable voltage to control your synthesizer. It also provides an LFO with triangle and positive-only square waveforms, and a random output that is sampled at the LFO rate. The range of the LFO goes from around 1s/cycle at the slow end to 70ms/cycle at the fast end (around 1Hz to 14Hz). It adds a glissando feature, which puts the bender pedal through the sample-and-hold instead. It has two outputs, which can be switched on and off, and which can output either the LFO alone, the pedal voltage alone, or a mix of both. One output runs at ±1.2V peak, the other at about ±5V. An LED indicates the LFO rate. It is powered by two 9V PP3-style batteries.

Inside, there is a small PCB with a few dozen components on, and a whole lot of wiring connecting the panel-mounted pots, switches, and jacks. Some components are soldered directly to the panel parts, and there are multiple wires of the same colour that don’t always run to the same points, so trouble-shooting is slightly messy. Luckily, it’s a simple enough circuit, and the spaghetti wiring is the only thing that need cause any headaches here.

Inside the Korg MS-04 modulation pedal. So many wires!

Inside the Korg MS-04 modulation pedal. So many wires!

The only schematic I could find online was blurry and hard to read, and lacks component numbering. I did my best to clear it up, and added the missing information. Unfortunately, half way through, my software crashed and my only saved file was of lower quality than I would have liked – hence the soft text over about half the image. I’d already put plenty of time in by this point, so it’ll have to do!

My additions are self-explanatory, I think. Parts that are not numbered are soldered directly onto panel hardware. The only missing values are the diodes – D2 to D5 are plain old signal diodes, D1 is a zener that I failed to make note of during repair. Sorry.

There seems to have been a change in some component values during production. These are labelled with ‘1’ and ‘2’ in black squares. The unit I took my details from had the lower value resistors and larger capacitor at points ‘2’.

There is no protection against only one battery being installed. The unit is switched on by the insertion of a cable into either output jack, so it is advised to remove the connections before fitting/replacing the batteries.

Korg MS-04 schematic, enhanced with component designations

Korg MS-04 schematic, enhanced with component designations (JPG)

Here’s the Korg MS-04 schematic as PDF download.

And here’s a quick video of it working:

Tags: , , , , , , , , , , , , , , , , , , ,

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: